Masquepen
Artist Liquid Masking Fluid Tool

A fine-line design mask fluid tool for arts and crafts. Works like a pen.

Apply masking liquid without a brush!

Making a continuous line of masking fluid is the key to the masquepen. No other tool can do this! It is reuseable and will open imaginations!

Masquepens

The Masquepen is an applicator of a translucent masking fluid with a nylon 0.8 mm nib. Applies easily to most nonporous surfaces such as paper, glass, plastic, ceramic, finished wood, leather, even eggs!

Perfect for effects with: Watercolor, paint, rubber stamp, scrapbooking, glass etching (acid resistant), airbrush, card making, paper crafts, metal, jewelry, models and much more! Do not use on fabric.

About Masquepens...

MP1111 - Masquepen. One ounce masking fluid with applicator. Separate applicator at black line. Gravity feed liquid through nib and apply where needed. Blow dry with hair dryer, or let dry (several minutes). Remove masking fluid by rubbing with fingers.

MP1112 - Refill Bottle. A word on the fluid itself. It is a bluish, translucent liquid. With the translucent liquid you can apply masking fluid over colors allowing more flexibility as you can see what you have covered. Also, you can leave the fluid on for days without danger of staining. It will roll off easily as if it had been on the paper only minutes. The liquid is of an excellent quality.

MP1113 - SuperNib. Attachment nib. Place SuperNib over the end of the nib on the Masquepen. The line becomes extremely fine allowing for great detail works. When finished, place SuperNib on enclosed water squeeze bottle and pass water through SuperNib. Clean immediately after use.

MASQUEPEN INSTRUCTIONS FOR USE:

To open the Masquepen pull at the black circle on the applicator end. When finished, put the needle in the cap back into the exposed nib. There is no cleaning needed.
The SuperNib is different in its care. The SuperNib must be cleaned. There is an empty bottle with the SuperNib for water. Before using the SuperNib, fill the bottle with water and have it ready. Screw the applicator on the Masquepen bottle, or on a refill bottle and begin designing or drawing. The second you are done, unscrew the applicator and screw it on the water bottle and squeeze. You will notice inside the empty bottle a very fine needle for cleaning out that metal nib if necessary.